X-Spot is a wire location system for those pre-wires where you don’t always have a final decision on the finish.
The re-usable Xspot wire device is at the core of the Xspot wire location system and can be used to bury wires behind sheetrock, sheer walls, tongue and groove ceilings, stucco, as well as for future locations with conduit. Works with both wood and steel construction.
Key Applications
- Speakers
- Keypads
- Josh.ai Nano, Micro (Xspot Partner)
- Touchscreens (universal bracket)
- Light fixtures
- LED lights, (strip Lighting)
- Security Sensors
- Security Keypads
- Security Motions
- Surveillance Cameras
- Wireless Access Points (networks)
- Data jacks prewire
- Motorized Shades, Blinds and Drapes
- Future Projector screens
- TV locations
- Invisible speakers
- Thermostat
- Temperature Sensor
In addition to the X-spot wire device the Xspot system includes the following:
- Xstrap, universal mounting option
- Most common and easiest solution. Span any distance between studs or joists to position the wire in the perfect spot for later, knowing it will be right where you left it.
- Roll out as much as needed to place the Xspot right where you want to come back to and install your technology.
- Holes in strap center over magnet in Xspot holes are .5” apart, acts like tape measure
- XRing, single gang mud ring
- The best fitting box in the project, always flat to the back of the wall, no gaps behind the wallplate.
- Perfect for future TVs, wireless access points, projectors or anything that needs a box and/or wallplate to trim.
- Having a box in place makes for a better and easier trim.
- Xtreme, deep sensing tool
- Quickly passing over the Xtreme locator over the general area of the Xspot, use the Xtreme locator with it’s 68 lbs of pull to find the Xspot hidden in the wall. Then flip it to the opposite side and let reverse polarity confirm you’ve found your Xspot.
- Xcentric, centering tool
Once you’ve found the general area using the Xtreme, let the Xcentric pop to the center of the Xspot and mark it’s location by drawing a mark into each of the inside four corners. Make an “X” with your four marks and drill confidently into the surface exposing the Xspot. Pull the Xspot straight out and re-use.
Contact SoundTech for more information: (303) 650-1050
